Vaillant ecoTEC VU Betriebsanleitung Seite 23

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 36
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 22
Troubleshooting
Operating instructions ecoTEC plus 0020116701_00 23
7
7.2 Detecting and rectifying malfunctions
If problems occur whilst operating your boiler, you can
carry out the following self-checks:
Problem Possible cause Solution
No hot water, heating stays
cold;
Boiler does not start
Building gas isolator cock closed
> Open building gas isolator cock (¬ Sec-
tion 5.1.1)
Building power supply switched off > Switch on building power supply
On/off switch on boiler switched off
> Switch on the on/off switch on the
boiler(¬ Section 5.1.2)
The heating flow temperature is set too low or in the
"Heating off" position (¬ Section 5.6.2) and/or the
hot water temperature is too low
> Set the heating flow temperature to the
desired temperature (¬ Section 5.2) and/or
set the hot water temperature to the desired
temperature (¬ Section 5.3.1 and 5.4)
Filling pressure of the heating system too low
> Top up the heating system with water
(¬ Section 5.1.4)
Air in the heating system
> Purge the radiators.
> If the problem occurs again:
Contact your heating engineer
Ignition malfunction
> Press the reset button
> If the problem occurs again:
Contact your competent person (¬ Sec-
tion 7.4)
DHW mode without any prob-
lems;
Heating does not start:
No heating demand via the controller
> Check the timer programme on the control-
ler and correct it if necessary.
> Check the room temperature and, if
required, correct the target room tempera-
ture
(¬Section5.5; ¬Controller operating
instructions).
7.1 Detecting and rectifying malfunctions
> If, after checking the points mentioned in Tab. 7.1, your
boiler still shows signs of a fault, contact your approved
competent person to troubleshoot the problem.
7.3 Rectifying a water shortage
0,7bar
7.2 Display of the filling pressure for the heating system is too
low
If the filling pressure for the heating system falls below
0.08MPa (0.8 bar), the right-hand bar display and the cur-
rent filling pressure flash in the display.
Seitenansicht 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare